Animal experiments were performed following the National Institutes of Health Guide for the Care and Use of Laboratory Animals in compliance with ARRIVE guidelines [20]. Use of Laboratory Animals and the animal protocols were approved by the Institutional Animal Care and Use Committee (IACUC) at Penn State College of Medicine. Data supporting the findings of this study are available from the corresponding author upon reasonable request. All data analyses were performed in a blinded manner.
Transient Intraluminal Middle Cerebral Artery Occlusion (tMCAO) Model
Adult male Sprague-Dawley rats (weighing 280-320 g, Charles River Laboratories, Wilmington, Massachusetts, USA) were subjected to 2 hours of tMCAO followed by reperfusion, as we described previously [21]. Briefly, animals were anesthetized with isoflurane (5% for induction and 2% for maintenance). A silicon-coated nylon monofilament (#503934PK5Re, Doccol Corp.) was advanced through the external carotid artery into the internal carotid artery until lodging proximal to the origin of the middle cerebral artery (MCA). Regional cerebral blood flow (rCBF) in the MCA territory (2 mm posterior and 5 mm lateral to the bregma) was monitored with a Laser doppler flowmetry (MSP300XP; ADInstruments Inc). Only animals that showed sustained ischemia to less than 15% rCBF of preischemic baselines were included in this study. During the procedure, body temperature was maintained at 37.0 ± 0.5°C using a feedback-regulated heating pad system. PE-50 catheters were placed into the vein for drug administration.
Experimental Protocols
To test the dose-response of TGX-221, rats were subjected to tMCAO and randomly assigned into the following 4 groups: vehicle [ethanol/cremaphor/N,N-dimethylacetamine/water (10/10/10/70%)] and varied doses of TGX221 including 0.3, 1, and 3 mg/kg. The range of doses was based on previous publications for animal experiments [22][23]. TGX221 or an equal volume of vehicle was administrated at 2 hours and repeated at 24 and 48 hours after stroke onset using a syringe infusion pump for 2 minutes. The modified Bederson score, used to determine global neurological function, was performed by a blinded investigator before and 72 hours after stroke, as we described previously [21]. The grip strength test used to determine the motor function and deficit after stroke was also performed with an Animal Grip Strength System (Bioseb, Pinellas Park, FL USA). Animals were euthanized with CO2 at 72 hours after stroke. For randomization, the web tool www.randomizer.org was used. Animals were randomly assigned to each group via random numbers generated on an Excel spreadsheet. Based on the dose-response assessment, the optimal dose of TGX221 (3 mg/kg) was chosen for further studies.
Infarct Volume and Hemorrhage
The infarct volume was measured in TTC-stained coronal sections at 72 hours after stroke. Then, the sections were homogenized and the hemoglobin levels were assessed by a spectrophotometric assay using Drabkin reagent (SigmaAldrich) as described previously [21][24].
Immunohistochemistry
At 24 hours after stroke, animals were euthanized with CO2. Brains were removed and fixed in 4% paraformaldehyde. A standard paraffin block was obtained from the center of the ischemic lesion (bregma -0.4 to -1.4 mm). 5 μm thick coronal sections were cut. Every tenth coronal section for a total of 5 sections was used for immunohistochemistry. Double immunostaining was used to detect fibrin and platelets deposited within brain microvessels (marked by endothelial barrier antigen [EBA] staining) as described previously [24][25]. The section was incubated with primary antibodies overnight at 4 °C and then incubated with fluorescent secondary antibodies for 1 hour at RT. Isotype controls were used as negative controls. To maintain consistency within and between animal groups, two predefined fields within the cortical ischemic boundary zone (IBZ) were selected as regions of interest (ROI), as shown in Fig. 2E.
Cerebral Microvascular Patency
Cerebral microvascular patency was assessed by the FITC-dextran labeled vessels, as we described previously [24]. Briefly, 1 ml of FITC-dextran (50 mg/ml, 2×106 MW, Sigma-Aldrich) was injected intravenously and allowed to circulate for 5 minutes. Then, the animals were euthanized by cervical dislocation. The brain samples were collected and 100 µm coronal sections were cut using a vibratome. Five (5) coronal sections (at the bregma level: + 0.2, -0.4, -1.0, -1.6, -2.0 mm) of each brain were selected for the measurement of cerebral perfusion. The ROI was defined as described above. To quantify the microvascular patency, the intensity of FITC-dextran was quantified using NIH Image Software. Data are presented as a percentage of the fluorescence intensity in the ipsilateral hemisphere compared to sham controls.
Platelet Activation and Platelet-Leukocyte Aggregates
At 24 hours after stroke, the blood sample was drawn from the abdominal aorta in 1:7 (v/v) of acid–citrate–dextrose buffer under deep anesthesia. For the evaluation of platelet activation, the surface expression of P-selectin and the ability to bind FITC-fibrinogen were measured. Samples were co-stained with the APC mouse anti-rat CD42d (1:200, RPM.4) and PerCP/Cy5.5 mouse anti-rat CD62P (1:100, RMP-1) for 20 minutes at RT, or incubated with FITC-conjugated rat fibrinogen (innovative-research,100 μg/ml) for 30 minutes at 37 °C. After that, the reaction was stopped by adding 1 ml PBS, and the samples were analyzed on the BD Accuri™ C6 flow cytometer. For detection of platelet–leukocyte aggregates (PLA) formation, samples were co-stained with anti-rat CD42d (1:200, RPM.4), anti-rat granulocytes (1:100, RP-1), anti-rat CD11b (1:100, ED8) and anti-rat CD45 (1:100, OX-1) at RT for 20 minutes. Isotype-matched control antibodies were used as negative controls. Then, the red blood cell was lysed with red blood cell lysis buffer. Before staining, all samples (10ul whole blood) were diluted 1:10 with Flow Cytometry Staining Buffer (eBioscience) containing rat Fc block anti-rat CD32 and incubated for 10 minutes at RT.
Platelet Protein Extraction and Western Blot
The anticoagulated blood sample was centrifuged at 220 g for 20 minutes, and the platelet-rich plasma (PRP) was collected and transferred to a new tube for centrifugation at 480 g for 20 minutes at RT. The supernatant (plasma) was collected and stored at -80°C for further ELISA assay to detect the concentration of TXB2 (ADI-900-002, Enzo Life Sciences). Then, suspend the pellet (pure platelet) with 10 volumes of Thermo Scientific M-PER Mammalian Protein Extraction Reagent containing protease/phosphatase inhibitor Cocktail (Cat:5872, Cell Signal). The suspension was subjected to three cycles of sonication of 5 seconds each and centrifuged at 13,000 g at 4 °C for 10 minutes. 50 µg total protein per lane was separated by SDS-PAGE and transferred onto polyvinylidene difluoride (PVDF) membranes. The membranes were incubated in blocking buffer (5 % w/v nonfat dry milk in Tris-buffered saline, 0.05 % Tween-20 [TBS-T]) for 1 hour at RT, and then incubated with primary antibodies overnight at 4 °C. Next, the membranes were incubated with horseradish peroxidase-conjugated secondary antibody at RT for 1 hour.
Platelet Aggregation Assay
PRP was collected as above described and platelet-poor plasma (PPP) was obtained from the remaining sample by centrifugation at 1500g for 30 minutes. The platelet concentration was adjusted to 5 x 108/ml by mixing PRP and PPP. Platelet aggregation was measured using an optical model 700 aggregometer (Chrono-Log) at 37°C under constant stirring (1200 rpm). PRP (250 ul per tube) was incubated without or with different doses of TGX221 at RT for 30 minutes and then aggregation was induced with 10 µmol/L ADP (Cat: 20398-34-9, Sigma). Aggregation was measured as changes in light transmission for 6 minutes at 37°C.
Tail Bleeding Time Assay
Tail bleeding time was measured in rats using a modified tail-cutting method [24]. At 24 hours after stroke, animals were anesthetized with isoflurane and placed on a feedback-regulated heating pad system. Bleeding times were measured by the transaction of the tail, 2 mm from the tip using a disposable surgical blade. The cut was dabbed with filter paper every 15 seconds until the paper was no longer stained red with blood. Bleeding time was then taken as the time when the blood stopped flowing from the cut tail.
Statistical Analysis
All results were expressed as mean ± standard deviation (SD). GraphPad Prism 8.0 software package was used for statistical analysis. Unless otherwise indicated, multiple comparisons were made using a 1-way analysis of variance (ANOVA) followed by the Bonferroni post hoc test. If only 2 groups were compared, an unpaired, 2-tailed Student t-test was applied. P<0.05 was considered statistically significant.