Aiming at the current problem that the cutting chips cannot be automatically recovered in the hole-making process of carbon fiber reinforced resin matrix composites, This article first introduces a new type of drilling chip removal technology system-suction type internal chip removal system, which can timely and effectively discharge the powdery chips generated in CFRP hole processing during cutting; Secondly, in view of the problem of the internal runner design of the internal chip removal drill used in the system, this article conducted the following research: 1) Based on cutting experiments and statistical methods, classify the chips produced in CFRP hole making, and give the chip distribution rules; 2) Secondly, on the basis of fluid mechanics, using FLUENT simulation method, on the basis of defining the center distance and center angle of the inner runner for the design of the internal chip removal drill bit, the center distance and the center angle of the inner runner are given. The influence law of the chip removal center angle and the cross-sectional shape of the internal runner on the chip removal effect of the tool internal runner; 2) Based on fluid mechanics, using FLUENT simulation method, on the basis of defining the center distance of the inner runner and the center angle of the inner runner, the center distance of the inner runner, the center angle and the cross-sectional shape of the inner runner are given to the tool The influence law of the chip removal effect of the internal runner; Finally, a suction type internal chip removal system was built, and the experimental method was used to verify the correctness of the internal runner design of the internal chip removal tool.