With the persistent scaling of semiconductor technology, the embedded multi-processor platforms lifetime reliability has been the primary concern for the industry. The advancements in technology permit several microprocessors integration, dedicated digital hardware, and at times mixed-signal circuits on a single silicon die, specifically multi-processor system-on-a-chip (MPSoC). In this paper, the design and analysis of CMOS based MPSoC is made. A CMOS based MPSoC is designed with 45nm technology. In this design, ADC converter is used in which 10-bit data is given as input, and are converted into digital data. A double feedback edge triggered flip flop is designed. The implementation of flip flop, based on both feedback and triggering process, is more effective in the elimination of error occurrence. Power Gating (PG) technique is proposed which exploits the stacking effect to achieve high energy efficiency. Binary controlled stacked SRAM cell, based on a parallel cross-coupling feedback controller, is implemented to reduce the leakage loss and ground bouncing noise. An inverter, based on NMOS and CMOS, is used for the inverting process. The input voltage of 5v is given and is varied. Then, a 2-bit counter is employed, which is responsible for counting down or counting up. The counter should count down if the signal is high. The counter should count up, if the signal is low. Thus, this design will be helpful in the implementation of compact processing system which may also be employed for many real-time applications where there is a need of compact device. The benefits of this multi processors integration will be helpful in speeding the process thereby reducing the leakage power loss, power consumption, delay factor and so on. The analysis of performance is carried out using CMOS based Tanner EDA, and the outcomes are represented.