1 Devanathan, R. Recent developments in proton exchange membranes for fuel cells. Energy Environ. Sci. 1, 101–119, doi: 10.1039/B808149M (2008).
2 Çelik, S. Ü., Bozkurt, A. & Hosseini, S. S. Alternatives toward proton conductive anhydrous membranes for fuel cells: Heterocyclic protogenic solvents comprising polymer electrolytes. Prog. Polym. Sci. 37, 1265–1291, doi: 10.1016/j.progpolymsci.2011.11.006 (2012).
3 Mauritz, K. A. & Moore, R. B. State of understanding of Nafion. Chem. Rev. 104, 4535–4585, doi: 10.1021/cr0207123 (2004).
4 Zhang, J. et al. High temperature PEM fuel cells. J. Power Sources 160, 872–891, doi: 10.1016/j.jpowsour.2006.05.034 (2006).
5 Zhu, Y., Zhu, W. H. & Tatarchuk, B. J. Performance comparison between high temperature and traditional proton exchange membrane fuel cell stacks using electrochemical impedance spectroscopy. J. Power Sources 256, 250–257, doi: 10.1016/j.jpowsour.2014.01.049 (2014).
6 Schmidt, T. J. & Baurmeister, J. Durability and reliability in high-temperature reformed hydrogen PEFCs. ECS Transactions 3, 861–869, doi: 10.1149/1.2356204 (2006).
7 Bose, S. et al. Polymer membranes for high temperature proton exchange membrane fuel cell: Recent advances and challenges. Prog. Polym. Sci. 36, 813–843, doi: 10.1016/j.progpolymsci.2011.01.003 (2011).
8 Li, Q., Jensen, J. O., Savinell, R. F. & Bjerrum, N. J. High temperature proton exchange membranes based on polybenzimidazoles for fuel cells. Prog. Polym. Sci. 34, 449–477, doi: 10.1016/j.progpolymsci.2008.12.003 (2009).
9 Ma, Y. L., Wainright, J. S., Litt, M. H. & Savinell, R. F. Conductivity of PBI membranes for high-temperature polymer electrolyte fuel cells. J. Electrochem. Soc. 151, A8–A16, doi: 10.1149/1.1630037 (2004).
10 Yu, S., Xiao, L. & Benicewicz, B. C. Durability studies of PBI‐based high temperature PEMFCs. Fuel Cells 8, 165–174, doi: 10.1002/fuce.200800024 (2008).
11 Li, Q., He, R., Jensen, J. O. & Bjerrum, N. J. PBI‐based polymer membranes for high temperature fuel cells – Preparation, characterization and fuel cell demonstration. Fuel cells 4, 147–158, doi: 10.1002/fuce.200400020 (2004).
12 Xiao, L. et al. High-temperature polybenzimidazole fuel cell membranes via a sol-gel process. Chem. Mater. 17, 5328–5333, doi: 10.1021/cm050831 (2005).
13 Kim, J., Kim, M., Lee, B.-G. & Sohn, Y.-J. Durability of high temperature polymer electrolyte membrane fuel cells in daily based start/stop operation mode using reformed gas. Int. J. Hydrogen Energy 40, 7769–7776, doi: 10.1016/j.ijhydene.2014.12.122 (2015).
14 Lang, S., Kazdal, T. J., Kühl, F. & Hampe, M. J. Experimental investigation and numerical simulation of the electrolyte loss in a HT-PEM fuel cell. Int. J. Hydrogen Energy 40, 1163–1172, doi: 10.1016/j.ijhydene.2014.11.041 (2015).
15 Wei, L., Liao, Z., Suo, Z., Chen, X. & Jiang, F. Numerical study of cold start performance of proton exchange membrane fuel cell with coolant circulation. Int. J. Hydrogen Energy 44, 22160–22172, doi: 10.1016/j.ijhydene.2019.06.147 (2019).
16 Oszcipok, M. et al. Portable proton exchange membrane fuel-cell systems for outdoor applications. J. Power Sources 157, 666–673, doi: 10.1016/j.jpowsour.2006.01.005 (2006).
17 Amamou, A. A., Kelouwani, S., Boulon, L. & Agbossou, K. A Comprehensive review of solutions and strategies for cold start of automotive proton exchange membrane fuel cells. IEEE Access 4, 4989–5002, doi: 10.1109/access.2016.2597058 (2016).
18 Maruo, T. et al. Development of fuel cell system control for sub-zero ambient conditions. SAE Technical Paper Series, doi:10.4271/2017-01-1189 (2017).
19 Jiang, W., Song, K., Zheng, B., Xu, Y. & Fang, R. Study on fast cold start-up method of proton exchange membrane fuel cell based on electric heating technology. Energies 13, 4456|1–26, doi: 10.3390/en13174456 (2020).
20 Wen, J. et al. Alternate hydrogen pump method enables start-up from −30°C for graphite-bipolar-plate proton exchange membrane fuel cells. J. Electrochem. Soc. 166, F1112–F1116, doi: 10.1149/2.0091914jes (2019).
21 Lee, K.-S., Spendelow, J. S., Choe, Y.-K., Fujimoto, C. & Kim, Y. S. An Operationally flexible fuel cell based on quaternary ammonium-biphosphate ion pairs. Nat. Energy 1, 16120|1–7, doi: 10.1038/nenergy.2016.120 (2016).
22 Lee, K.-S. et al. Intermediate temperature fuel cells via an ion-pair coordinated polymer electrolyte. Energy Environ. Sci. 11, 979–987, doi: 10.1039/C7EE03595K (2018).
23 Lee, A. S., Choe, Y.-K., Matanovic, I. & Kim, Y. S. The energetics of phosphoric acid interactions reveals a new acid loss mechanism. J. Mater. Chem. A 7, 9867–9876, doi: 10.1039/c9ta01756a (2019).
24 Atanasov, V. et al. Synergistically integrated phosphonated poly(pentafluorostyrene) for fuel cells. Nat. Mater., 20, p370–377; doi: 10.1038/s41563-020-00841-z (2021).
25 McKeown, N. B. & Budd, P. M. Polymers of intrinsic microporosity (PIMs): Organic materials for membrane separations, heterogeneous catalysis and hydrogen storage. Chem. Soc. Rev. 35, 675–683, doi: 10.1039/b600349d (2006).
26 Carta, M. et al. An efficient polymer molecular sieve for membrane gas separations. Science 339, 303–307, doi: 10.1126/science.1228032 (2013).
27 Xu, Z., Liao, J., Tang, H., Efome, J. E. & Li, N. Preparation and antifouling property improvement of Tröger's base polymer ultrafiltration membrane. J. Membr. Sci. 561, 59–68, doi: 10.1016/j.memsci.2018.05.042 (2018).
28 Zuo, P. et al. Sulfonated Microporous polymer membranes with fast and selective ion transport for electrochemical energy conversion and storage. Angew. Chem. Int. Ed. 59, 9564–9573, doi: 10.1002/anie.202000012 (2020).
29 Yang, Z. et al. Highly conductive anion-exchange membranes from microporous Tröger's base polymers. Angew. Chem. Int. Ed. 55, 11499–11502, doi: 10.1002/anie.201605916 (2016).
30 Tan, R. et al. Hydrophilic microporous membranes for selective ion separation and flow-battery energy storage. Nat. Mater. 19, 195–202, doi: 10.1038/s41563-019-0536-8 (2020).
31 Patel, H. A. et al. Proton conduction in Tröger's base-linked poly(crown ether)s. ACS Appl. Mater. Interfaces 10, 25303–25310, doi: 10.1021/acsami.8b05532 (2018).
32 Ma, X. et al. Facile synthesis and study of microporous catalytic arene-norbornene annulation–Tröger’s base ladder polymers for membrane air separation. ACS Macro Lett. 9, 680–685, doi: 10.1021/acsmacrolett.0c00135 (2020).
33 Liu, X. et al. Oriented proton-conductive nano-sponge-facilitated polymer electrolyte membranes. Energy Environ. Sci. 13, 297–309, doi: 10.1039/c9ee03301g (2020).
34 Zhou, S. et al. Alkaline polymers of intrinsic microporosity: high-conduction and low-loss anhydrous proton exchange membranes for energy conversion. J. Mater. Chem. A 9, 3925–3930, doi: 10.1039/d0ta12100b (2021).
35 Zhang, E. et al. NMR analysis of phosphoric acid distribution in porous fuel cell catalysts. Chem. Commun. 57, 2547–2550, doi: 10.1039/d0cc07738k (2021).
36 Carta, M. et al. The synthesis of microporous polymers using Tröger's base formation. Polym. Chem. 5, 5267–5272, doi: 10.1039/c4py00609g (2014).
37 Liao, K.-S. et al. Determination of free-volume properties in polymers without orthopositronium components in positron annihilation lifetime spectroscopy. Macromolecules 44, 6818–6826, doi: 10.1021/ma201324k (2011).
38 Provencher, S. W. Contin: A general purpose constrained regularization program for inverting noisy linear algebraic and integral equations. Comput. Phys. Commun. 27, 229–242, doi: 10.1016/0010-4655(82)90174-6 (1982).
39 Kirkegaard, P., Eldrup, M., Mogensen, O. E. & Pedersen, N. J. Program system for analysing positron lifetime spectra and angular correlation curves. Comput. Phys. Commun. 23, 307–335, doi: 10.1016/0010-4655(81)90006-0 (1981).
40 Thommes, M. Physical adsorption characterization of nanoporous materials. Chem. Ing. Tech. 82, 1059–1073, doi: 10.1002/cite.201000064 (2010).
41 Sebastiani, D. Current densities and nucleus-independent chemical shift maps from reciprocal-space density functional perturbation theory calculations. ChemPhysChem 7, 164–175, doi: 10.1002/cphc.200500438 (2006).
42 Aihara, Y., Sonai, A., Hattori, M. & Hayamizu, K. Ion conduction mechanisms and thermal properties of hydrated and anhydrous phosphoric acids studied with 1H, 2H, and 31P NMR. J. Phys. Chem. B 110, 24999–25006, doi: 10.1021/jp064452v (2006).
43 Xu, Z., Shi, J. L., Chen, X. & Jiang, X. K. 31P NMR study on some phosphorus-containing compounds. Chinese Chem. Lett. 11, 1057–1060, doi: (2000).
44 Guo, S.-Y., Guo, Q.-H., Tong, S. & Wang, M.-X. Synthesis of electron-deficient corona[5]arenes and their selective complexation with dihydrogen phosphate: Cooperative effects of anion-pi interactions. Angew. Chem. Int. Ed. 132, 8155–8160, doi: 10.1002/anie.201915839 (2020).
45 Harris, R. K., Thompson, T. V., Norman, P. R. & Pottage, C. Adsorption competition onto activated carbon, studied by magic-angle spinning NMR. Journal of the Chemical Society, Faraday Transactions 92, 2615–2618, doi: 10.1039/FT9969202615 (1996).
46 Dickinson, L. M., Harris, R. K., Shaw, J. A., Chinn, M. & Norman, P. R. Oxygen-17 and deuterium NMR investigation into the adsorption of water on activated carbon. Magnetic Resonance in Chemistry 38, 918–924, doi: 10.1002/1097-458X(200011)38:11<918::AID-MRC749>3.0.CO;2-7 (2000).
47 Uosaki, K., Okazaki, K. & Kita, H. Conductivity of Nafion membranes at low temperatures. J. Electroanal. Chem. Interfacial Electrochem. 287, 163–169, doi: n.a. (1990).
48 Soboleva, T. et al. Investigation of the through-plane impedance technique for evaluation of anisotropy of proton conducting polymer membranes. J. Electroanal. Chem. 622, 145–152, doi: 10.1016/j.jelechem.2008.05.017 (2008).
49 Aili, D. et al. Thermal curing of PBI membranes for high temperature PEM fuel cells. J. Mater. Chem. 22, 5444–5453, doi: 10.1039/c2jm14774b (2012).
50 Haider, R. et al. High temperature proton exchange membrane fuel cells: progress in advanced materials and key technologies. Chem. Soc. Rev., 50, 1138-1187; doi: 10.1039/d0cs00296h (2021).
51 Yang, J. S. et al. High molecular weight polybenzimidazole membranes for high temperature PEMFC. Fuel Cells 14, 7–15, doi: 10.1002/fuce.201300070 (2014).